To start configuring your device you will need to plug it in to your router/modem via it’s internet port with an Ethernet cable and connect a regular handset phone to it’s Phone port, then follow the steps below to start setup.

Manual Configuration

Start by dialing * * * from the connected phone, then press 1 to confirm your choice, this will return the IP address of your device being a number similar to 192.168.xxx.xxx.

Once you get the IP address, enter it in the URL address bar “http://” of your Internet Browser to get access to the Graphic User Interface of the Device.

If done properly, the following window should appear on your screen:

Once you get the Authentication Required window you will be prompted for a User Name and Password, the default credentials are:

Username: admin

Password: admin

After this, you should now be able to see the OBi Web interface.

Now on the left side of the screen please find the next options and follow the next steps:

  • System Management -> Auto Provisioning -> Auto Firmware Update -> Method : Disabled
  • System Management -> Auto Provisioning -> ITSP Provisioning -> Method : Disabled
  • System Management -> Auto Provisioning -> OBiTALK Provisioning -> Method : Disabled
  • Voice Services -> OBiTALK Service -> Enable : Unchecked

Please note you must remove the check mark from the “default” column, then under “Method” please use the ‘Drop Down Selection’ and choose Disabled.

Configuring the ITSP Profile

General Section
In this section you will set the name and the DigiMap you will use in the profile you configure. By default you will configure the profile A, unless you use the same device with another provider.

Name: Enter in your 09xxxxx Username

DigitMap: (0[1234578]xxxx xxxx)

SIP Section
In this section you can set the server and the port that you wish to register to.

Please note that in order to change the settings, you need to uncheck the Default box on the right hand side.
ProxyServer: voice.teltel.com.au
ProxyServerPort: 5060
RegistrarServer: voice.teltel.com.au
RegistrarServerPort: 5060

Additionally, you may want to change the RegisterExpires value to 300, scroll down, deselect the default box and set the value there from 3600 to 300.

Configuring Voice Services

In this section you can set your Main account/sub_account credentials like User name and Password. The Main account password by default is the same password as the Customer Portal.

AuthUserName: 09xxxxxx (Replace with your Main SIP account UserID or Sub Account user name, i.e. 0912345567678)
AuthPassword: ****** (Your SIP Account Password)

Once you have finished changing all those settings, click on the button Submit to save the changes and reboot your OBi device, your device should now be registered.